Are you a DIY kind of person? Don’t mind getting under the house into that nasty crawlspace or up in that hot attic? Perfect. This system is great for those who are looking to save a little money and do it themselves. All you have to do is send us a sketch of your crawlspace/basement/attic and answer a few of our questions. We can then have one of our engineers design your system to meet your specific needs. After the system is designed, we will then ship it to your front door!

Here is a checklist for information to include:

  • Give basic main dimensions of crawlspace layout (it does not have to be too accurate).
  • How many wall openings are there? Where are they located? Mark them on the sketch.
  • Are the openings a standard 8 x16 inch? If not, what size are they.
  • What is the square footage of the house foot print?
  • What is the average height of the crawlspace? What is the height in the highest and lowest points?
  • Indicate decks, porches and patios. How high is deck above the ground? Is the porch dirt filled or accessible?
  • Location of entrance(s) into crawlspace.
  • Where are the areas with the highest moisture or trouble spots? Indicate any standing water.
  • Indicate any large HVAC ducts that dissect the crawlspace.
  • Where are the outside compressors located?
  • Does the HVAC condensate discharge by gravity or pump?
  • In newer buildings, the chimney from a gas-fired HVAC heating section comes through the foundation wall (normally in 4” PVC pipe). If applicable, indicate where these pipes are.
  • Does the crawlspace have a French drain with a sump pump?
  • Indicate any dense shrubbery in close proximity of the walls.

Contact Information Needed:

Name:

Company (if applicable):

Address:

City, State and Zip:

Location of Crawlspace from layout sketch:

Name:

Address:

City, State and Zip:

Please fill in information and check off the best way to reach you.

Daytime Telephone:

Mobile Telephone:

Email:

Have A Fungal Growth Problem?

Contact Us Today